Assembly

Atenea, Hermes, Apolo, Artemis and Cronos   |  Zeus   |   Atenea+Ramps   |   Lateral framing profiles for recessed doormats  

Place the self-adhesive black foam strips pa­ra­lelly to each other with the ad­he­sive part facing upwards. Peel off the pro­tec­tive paper a few centimetres. The exterior foam strips must be at a distance between 2-5 cm from the edge. The profile with the Basmat label must be the last one to be installed.		Keep placing the Basmat profiles clicking one into the next one and sticking them down to the black foam.
	Continue the process until the last profile and adjust Basmat in the mat well. Insert the foam tubes under the initial and final wings.	Fix Basmat to the floor with adhesive or silicone. If desired, Basmat can be screwed to the floor (see Optional section).
Retire partially or slide the finish strips. Drill the initial and ending profile on both ends to fix Basmat to the floor.	Screw Basmat to the floor. Stick the finish strips to the aluminium profiles.

WARNING:

• The mats of plastic or brushes finish will be delivered with a self-adhesive angle (ref. V71029) to avoid the movement of the inserts (Please stick it at the end of the mat). If the mat is tight in the mat well, it is not necessary to use it. 
• The profiles must be clean in order to be assembled properly.
• It could be necessary more than a person to install big size doormats (approx 1 person each 1,5 m profile length). 
• The surface where Basmat is going to be installed must be flat and uniform.